Welcome to M.S.T.W. Planning District
The M.S.T.W. Planning District was established in 1979 by Order in Council #1018-77. The district was formed by the agreement between four municipalities: the City of Morden, R.M. of Stanley, R.M. of Thompson and City of Winkler to share the services of a Building Inspector. We have issued over 14,500 Building Permits from the time of our inception until December of 2010.
As of January 1, 2006, we began issuing plumbing permits for the municipalities in our district. We have the authority to issue building permits under Part 3 and Part 9 of the National Building Code for the planning district area. We have been contracted by the R.M. of Pembina the Town of Manitou to issue Part 9 building permits and provide building inspection services.
The MSTW Planning District is governed by a Board consisting of two representatives from each of the member municipalities’ councils. Our staff will be happy to answer any questions you may have.
Memo to all Contractors and Designers
RE: Deep Pile Foundations
Beginning July 1, 2015, MSTW Planning District will be enforcing the cross sections 22.214.171.124. of the Manitoba Building Code (2005). The main focus is for foundations for attached garages on piles and grade beams, and grade beams on pad and piers.
The practice of thickened edge slab on piles is not a recognized option in the Manitoba Building Code, without Engineering.
The thickened edge slabs are ideally suited for detached garages, but not for spanning from pile to pile. The sizing of friction piles calls for 16” diameter and 20’ deep with heavier rebar that extends the full depth of the pile.
It is important to note that some areas may not be suitable for deep pile foundations, and in such cases, the pad and pier foundation cross section may be the better option. Alternatively, an engineered foundation would be acceptable.
The upper portions of garage foundations will be required to be a grade beam. The beam dimensions and rebar sizes are provided in the cross sections.
The garage floor should be built independent of the grade beam to prevent possible frost heave and damage to the supporting structure.
See this website for the Manitoba Amendments.
If you have any questions or concerns, please feel free to contact our office at 204-822-6223.
Assistant Chief Building Inspector
MSTW Planning District
October 2013 MSTW Wastewater Management Plan
Lake Minnewasta Carrying Capacity StudyFINAL REPORT - Lake Minnewasta Carrying Capacity Study.pdf
The public is invited to attend a presentation of the Lake Minnewasta Carrying Capacity Study results and recommendations. WHEN: Thursday June 20, 2013 at 7 pm. WHERE: Morden Chiropractic Meeting Room in the Access Event Centre, 111 Gilmour St, Morden. For more information contact Peter Cantelon at 822-6223.
Policy Regarding RTMs (Ready to Move Homes) and the MSTW Planning District
At its May 23, 2013 meeting the board of MSTW passed motion 13 061 implementing the following policy to guide the permitting process for RTMs that are manufactured by businesses that do not have CSA certification to perform their own building and plumbing inspections:
- The building permit fee for such an RTM will be 50 percent less than the current residential permit fee.
- The building permit refundable deposit for such an RTM will be 50 percent less than the current residential permit refundable deposit.
- A full plumbing permit fee will be charged
- A full plumbing refundable deposit will be charged
- All such RTMs will be inspected according to the Manitoba Building Code (subset of the National Building Code).
- Under the authority of The Planning Act of Manitoba, Part 9, a building permit will only be approved for all such RTMs built within the MSTW Planning District that have been inspected by building inspectors of the MSTW Planning District or inspectors approved by an MSTW building inspector.
- A copy of this policy will be attached to every RTM permit.
Development Plan Surveyhttp://www.surveymonkey.com/s/MSTW_Development_Plan
Did you know?
Radon is a radioactive gas found naturally in the environment. It is produced by the decay of uranium found in soil, rock or water. Radon is invisible, odourless and tasteless and emits ionizing radiation. As a gas, radon can move freely through the soil enabling it to escape to the atmosphere or seep into buildings. When radon escapes from the bedrock into the outdoor air, it is diluted to such low concentrations that it poses a negligible threat to health. However, if a building is built over bedrock or soil that contains uranium, radon gas can be released into the building through cracks in foundation walls and floors, or gaps around pipes and cables.
Remedial measures should be undertaken in a dwelling whenever the average annual radon concentration exceeds 200 Bq/m³ in the normal occupancy area. The construction of new dwellings should employ techniques that will minimize radon entry and will facilitate post-construction radon removal, should this subsequently prove necessary. As per the National Building Code, subfloor depressurization is now required.
There are several different radon home test kits available commercially.
Get more information on radon
Contact your regional office of the CMHC (Canadian Mortgage and Housing Corporation) - check this list of CMHC offices and call the one closest to you.
Read this booklet: Radon - A guide for Canadian Homeowners. This is a 25-page booklet from the CMHC (Canadian Mortgage and Housing Corporation). It’s available free online.
Smoke Alarm Requirements
Please note that effective April 1, 2011, a smoke alarm is required on every floor of a dwelling unit, and an additional smoke alarm is required in every sleeping room. All smoke alarms must be "hardwired", not battery operated. Reference National Building Code Section 126.96.36.199.1(a,b).
Major Technical Changes to the 2010 NBC, NFC and NPC
The Canadian Commission on Building and Fire Codes is pleased to introduce FREE online presentations on the 2010 National Model Construction Codes. These complimentary online presentations provide detailed overviews of major technical changes in the 2010 editions of the National Building Code of Canada (NBC), National Fire of Canada (NFC) and National Plumbing Code of Canada (NPC). Each presentation is approximately 30 minutes in length and is available in the "Links" section